Make Motor Mount
flickr:3995072780

Overview

The motor mount is the angle stock with two 1/4" holes for 23 size stepper motor, two slots and three holes compatible with the perforated angle (1" apart).

NEMA23 has 1/16" thick circular protrusion around the shaft which prevents from mounting it flush with the mount. 1/16" thick steel or rubber washers (one or more) are used in between the motor and the mount. Rubber washers significantly reduce vibrations and noise.

Materials

  • Aluminium angle, 1"x1", 1/8" thick

Source Files

Making

Make the angle piece from SVG or PDF template, according to the instructions in Howto section

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License