Make Linear Bearings V2

Overview

flickr:8434014295

Linear bearing is made from aluminum channel (or part of rectangular/square tube), aluminum angle, bearings, shims, fasteners and Delrin rings. Like the sliding element, it consists of 1½" long mounting section(s) and 1" long bearing section(s).

The bearing section consists of pair of wheels (bearing+ring) mounted on the angular wheel mount attached to the channel by a screw. The mounting section has a pattern of holes on each side of the tube to mount perforated angle.

There are 3 sizes of the linear bearing:
3.5": bearing section / mounting section / bearing section
2.5": bearing section / mounting section
1": bearing section

Version Info

Parts List

qty part source
1 rectangle tube 2x1.5x1/8, 3.5" long http://onlinemetals.com
2 aluminum angle equal 3/4x1/8, 1 1/8" long http://onlinemetals.com
4 linear-bearing delrin rings custom part, buy or machine on lathe
4 bearing #R3-2RS http://www.vxb.com/page/bearings/PROD/kit715
4 precision shim 10 http://www.mcmaster.com/#91140A255
4 screw 10-24 3/8L pan http://www.mcmaster.com/#90272A240
2 screw 10-24 3/4L bsc http://www.mcmaster.com/#92949A245
2 hex nut 10-24 http://www.mcmaster.com/#90480A011

Many cheap R3 bearings seem to have inner diameter a bit less than 3/16" (by 0.005" or sometimes even more), so it's recommended to use regular zinc plated steel screws (3/8" length) since their OD is also a bit less. For example, stainless steel screws may not fit in the R3 bearing.

Source Files

Making

To make the angular wheel mount, you will need transfer punch set (such as this this) and 10-24 tap in addition to the tools specified in Tools section.

Body/channel piece

Make the channel piece from SVG templates, according to the instructions in Howto section.

Angular wheel mount

Make the angular wheel mount from SVG templates, according to the instructions in Howto section.

To mark the wheel mounting holes in the angle, use 3/8" dia transfer punch and press it against the inner wall of the angle when punching. This will ensure that the holes are accurate, resulting in good alignment of the wheels.

The DIY version does not have a center slot - instead, a hole is drilled through the center of the angle and tapped 10-24.

Delrin ring

  • Pre-fabricated rings will be available for purchase separately from a kit.
  • Delrin rings can be made on a lathe

Assembly

flickr:8041630247

One edge of the Delrin ring has an inner lip. Chamfer the opposite edge of the ring (inner circumference) with a hobby knife.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License